Car 2013

1. Open the hood and remove both T25 Torx screws found at the top of the headlights. This is done from outside of the vehicle.
2. Loosen the two T25 Torx screws found on each side of the headlights. To get a better reach of the screws, attach an extension to the screwdriver.
3. Pull out the headlights and press the metal clips behind them in order to detach the headlights from the wiring.
4. Pull out the turn signal bulbs at the sides of the headlight units.
5. Pull out the headlight back covers and press the metals clips behind the bulbs to unplug the wiring. Slide out the xenon and high beam bulbs using a cloth to prevent them from getting smeared with oil from your skin.
6. Repeat the steps in reverse with the new xenon bulbs.

1. Turn your vehicles ignition off and press and hold the two outer buttons on your Audis system until the red indicator light begins to flash.
2. Press and hold the button on the remote you wish to program until the indicator light begins flashing.
3. Leave your car and hold your remote near the right headlight.
4. Press the open button on your remote and hold it until the hazard lights blink three times.
5. Press and hold the HomeLink training button inside of the car until the indicator light glows solid. If the light does not turn solid, continue to the following steps.
6. Press and hold the smart button on your garage motor, located on the side or back near the antenna wire.
7. Press the train button on your Audi system within 30 seconds of pressing the smart button and wait for the indicator light to glow solid. The programming will now be complete and your remote will be ready to use.

1. Turn the vehicle off and locate the center button on the right side of the instrument panel.
2. Hold the center button while switching the ignition to the “ON” position. Release the center button and wait for the instrument panel display to read “SERVICE!”.
3. Press and hold the farthest button on the right near the center button. Wait for the service indicator light to clear, and then turn off the ignition.